1.1These test methods cover procedures for sampling and testing coal ash and raw or calcined pozzolans for use in concrete.
1.2The procedures appear in the following order:
Sections Sampling 7 CHEMICAL ANALYSIS Reagents and apparatus 10 Moisture content 11 and 12 Loss on ignition 13 and 14 Silicon dioxide, aluminum oxide, iron oxide,
calcium oxide, magnesium oxide, sulfur
trioxide, sodium oxide and potassium
oxide 15 Ammonia 16 PHYSICAL TESTS Density 17 Fineness 18 Increase of drying shrinkage of mortar bars 19 - 21 Air-entrainment of mortar 22 and 23 Strength activity index 24 - 27 Water requirement 28 Effectiveness of Coal Ash or Natural Pozzolan in
Contributing to Sulfate Resistance 29
calcium oxide, magnesium oxide, sulfur
trioxide, sodium oxide and potassium
oxide 15 Ammonia 16 PHYSICAL TESTS Density 17 Fineness 18 Increase of drying shrinkage of mortar bars 19 - 21 Air-entrainment of mortar 22 and 23 Strength activity index 24 - 27 Water requirement 28 Effectiveness of Coal Ash or Natural Pozzolan in
Contributing to Sulfate Resistance 29
1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
Note 1:Sieve size is identified by its standard designation in Specification E11. The alternative designation given in parentheses is for information only and does not represent a different standard sieve size.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes (excluding those in tables) shall not be considered as requirements of this standard.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
More Standards PDF
ASTM E517-18
$30.00 $60.00
ASTM C1293-18
$29.00 $58.00
ASTM D4383-18
$36.00 $72.00
ASTM F3313-18
$31.00 $62.00