ANSI APPROVAL WITHDRAWN MARCH 2004
INTRODUCTION
Intent
The purpose of this procedure is to measure the forces or torques that are required to fully couple or uncouple a connector set.
Description
The connector set components are held in a fixture so that a controlled coupling force or torque can be applied. The force or torque is measured during the entire coupling and/or uncoupling cycle. The procedure is applicable to either twist type or push-pull type coupling mechanisms.
Alternative Procedures
This test procedure is an alternative to the measurement procedure, titled Engagement and Separation Force of IEC 874-1, Third Edition.
More Standards PDF
TIA TIA/EIA-455-227
$40.00 $81.00
TIA ANSI/TIA/EIA-606-A
$92.00 $184.00
TIA TIA-918
$77.00 $155.00
TIA TIA/EIA-455-226
$77.00 $155.00





