1.1This test method describes a means for determining the amount of fuel dilution present in an in-service lubricant. This is achieved by drawing into a surface acoustic wave (SAW) sensor vapor from the lubricant. Fuel vapor will be absorbed by the SAW sensor''s polymer coating. The amount of absorbance is then related to fuel content in the lubricant.
1.2The range of fuel dilution capable of being measured by the test method is from 0.1 % to 10.0 % by mass fuel dilution.
1.3This test method is specifically tailored to determining the fuel dilution of in-service lubricants, including newly utilized lubricants. The method is applicable to contamination with diesel, gasoline, and jet fuels.
1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Section 9.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D8004-23 History
ASTM D8004-23
$28.00 $57.00
ASTM D8004-15
$34.00 $68.00
More Standards PDF
ASTM D6978-05(2023)
$27.00 $55.00
ASTM F957-91(2023)
$28.00 $57.00
ASTM D8279-23
$62.00 $125.00
ASTM E181-23
$31.00 $63.00