1.1This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications.
1.2Applicable bolts, cap screws, and studs for use with nuts covered by this specification are covered by Specification F468.
1.3Terms used in this specification are defined in Terminology F1789 unless otherwise defined herein.
1.4The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
Note 1:This specification is the inch-pound companion to Specification F467M; therefore, no SI equivalents are presented in the specification.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM F467-24 History
ASTM F467-24
$34.00 $69.00
ASTM F467-13(2018)
$41.00 $83.00
ASTM F467-13
$29.00 $58.00
ASTM F467-13e1
$29.00 $58.00
ASTM F467-08
$29.00 $58.00
ASTM F467-08e1
$29.00 $58.00
More Standards PDF
ASTM F1431-92(2021)
$23.00 $46.00
ASTM D7931/D7931M-21a
$27.00 $54.00
ASTM E3236/E3236M-21
$29.00 $58.00
ASTM D2199-03(2021)
$23.00 $46.00